Solutions : Foundry Patterns & Negatives

In this section you will find various methods to make negatives and Patterns using our products.

A) Negatives can be made in a variety of methods.

B) Patterns: Abrasion resistant patterns can be made in a variety of methods:

Sort By:
Show:
Display: List Grid
  • MC2 - Fast Cast
    Fast Cast PU MC2 (SG2).   Easy to use fast cast resin. Ideal to make ornaments and general castings. Slightly slower than MC14. Working time 3 - 4 minutes. F33 filler is a low cost extender - it lowers the cost, and reduces heat generated.   Mix half of the F33 with Resin A and..
  • PU330 - PU88
    A two-component filled polyurethane casting resin, tough-elastic, hardness shore D 50, which results in easy to cast polymer with a 30 minute pot life. Non-hygroscopic PU, easy to handle. Main application is to make negatives, prototypes and electrical potting. It can filled with extra fillers..
  • PU6465 - PU Casting Resin
    PU6465 is polyurethane casting resin unfilled, 2-component, which results in a tough-elastic, impact resistant and highly abrasion-resistant polymer after full cure. PROPERTIES: Very high abrasion resistance; tough-elastic (semi-rigid); high impact strength; castabel up to 20 mm thick.  F..